Ika Vortex 1 Manuel d'utilisateur télécharger pdf (Page 8)

The IKA® VORTEX1 is maintenance-free. It is subject

only to the natural wear and tear of components and their

statistical failure rate. Clean the devices only whith the

following cleaning agents.

To remove use:

Dyes isopropyl alcohol

Constructions materials water containing tenside /

isopropyl alcohol

Cosmetics water containing tenside /

isopropyl alcohol

Foodstuffs water containing tenside

Fuels water containing tenside

Wear the proper protective gloves during cleaning of the

devices. Electrical devices may not be placed in the clean-

sing agent for the purpose of cleaning.

Before using another then the recommended method for

cleaning or decontamination, the user must ascertain

with the manufacturer that this method does not destroy

the instrument.

The IKA® VORTEX1 is designed for shaking test tubes.

Gently push the test tube into the soft attachment to start

shaking. Shaking stops as soon as you lift out the test

tube.

The shaking rate is set using the front knob (left stop =

approx. 1000 rpm - right stop = approx. 2800 rpm).

Please unpack the device carefully and check it for dama-

ge. It is important that any transport damage is detected

when the device is unpacked. If necessary, an inventory

of the damage should be made immediately (postal ser-

vice, railway, haulage company).

As supplied, the package contains:

The IKA® VORTEX1, a plug-in power supply unit and an

instruction manual.

Connect the appliance to a socket (please refer to the

information in the ”Technical Data” section).

Correct use

Unpacking

Commissioning

Maintenance and cleaning

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Pas de commentaire

Ika Vortex 1 Manuel d'utilisateur Page 8